NOTE- With the addition of SDI output card, (Option E),not provided, these can then also convert analog compnent in YUV/RGB selectable to SDI out All 5 power up, otherwise sold AS IS. (One unit sais "error" on it so consider it a parts unit). Buy 5 units for next to nothing here..

The 3RU frame is a full featured chassis that accommodates any ten Avenue modules. Modules plug into a universal motherboard so that rear modules are not needed.
In addition to the ten module slots, there is a dedicated slot for the optional 5030 System Control module. One universal power supply comes with each frame. Redundant supply is optional ( included in this auction) and does not take up a slot in the frame. Touch Screen front door or plain front door are available. Plastic overlays for each module type are provided and slip over the corresponding BNCs on the backplane to identify the input and output designations on each type of module. In addition to the ten audio and video modules, the optional 5030 system control module adds a variety of control capabilities. Please refer to System Control Overview for more information. 5020 Power Supply Each Avenue 3RU frame comes with one 5020 Power Supply module installed. An optional redundant power supply is available if desired to provide backup. Power is provided to all modules in the frame, the front door fan and optional Touch Screen Panel. Frame Specifications The Avenue 3RU (5.25 inches) frame fits in a standard 19 inch rack. Any number of frames may be stacked together in any combination. A fan in the front door of each 3RU frame provides the necessary cooling for the frame. The fan is temperature sensitive and adjusts its speed accordingly. Should the fan fail, a red LED will light on the front panel. If using a remote control option, an alarm can be set to alert the user of fan failure. All critical components such as fuses, filter and fan are made to be accessible from the front of the unit. The 5160 Serial Digital Protection DA module is a fail-safe protection switch for monitoring and switching critical digital paths. When a fault is detected in the Primary input, the switch will activate, causing the Secondary (backup) input to be switched to the module’s distributed outputs. The switch can operate in two modes; automatic or non-resetting. The 5160 monitors the integrity of the Primary serial digital input stream and analyzes the audio and video content. Signal health and fault detection is determined by monitoring any or all of the following parameters: Timing Reference Signal (TRS), Black, Embedded Audio, Error Detection and Handling (EDH), and Freeze. A sophisticated black detection system is employed to activate the switch in the event signal is lost. It allows the user to select not only the threshold and percentage of non-black pixels, but also the portion of the picture to be considered. The 5420 Logo Inserter module keys a still logo or an animation over program material. Alternately the 5420 can supply separate fill and key to a production switcher. This module can be used in an Avenue 3RU or 1RU frame. Generate logos and animations in your favorite graphics software and then upload them into the 5420’s nonvolatile flash memory. Multiple logos and animations of varying sizes can be stored. Logo position and logo density can be adjusted from the Avenue control system, using an Avenue Touch Screen or Avenue PC, GPIs, serial interface and ethernet are also available for control. Sequences of logos, animations and transitions can be programmed.

The 3RU frame is a full featured chassis that accommodates any ten Avenue modules. Modules plug into a universal motherboard so that rear modules are not needed.
In addition to the ten module slots, there is a dedicated slot for the optional 5030 System Control module. One universal power supply comes with each frame. Redundant supply is optional ( included in this auction) and does not take up a slot in the frame. Touch Screen front door or plain front door are available. Plastic overlays for each module type are provided and slip over the corresponding BNCs on the backplane to identify the input and output designations on each type of module. In addition to the ten audio and video modules, the optional 5030 system control module adds a variety of control capabilities. Please refer to System Control Overview for more information. 5020 Power Supply Each Avenue 3RU frame comes with one 5020 Power Supply module installed. An optional redundant power supply is available if desired to provide backup. Power is provided to all modules in the frame, the front door fan and optional Touch Screen Panel. Frame Specifications The Avenue 3RU (5.25 inches) frame fits in a standard 19 inch rack. Any number of frames may be stacked together in any combination. A fan in the front door of each 3RU frame provides the necessary cooling for the frame. The fan is temperature sensitive and adjusts its speed accordingly. Should the fan fail, a red LED will light on the front panel. If using a remote control option, an alarm can be set to alert the user of fan failure. All critical components such as fuses, filter and fan are made to be accessible from the front of the unit. The 5160 Serial Digital Protection DA module is a fail-safe protection switch for monitoring and switching critical digital paths. When a fault is detected in the Primary input, the switch will activate, causing the Secondary (backup) input to be switched to the module’s distributed outputs. The switch can operate in two modes; automatic or non-resetting. The 5160 monitors the integrity of the Primary serial digital input stream and analyzes the audio and video content. Signal health and fault detection is determined by monitoring any or all of the following parameters: Timing Reference Signal (TRS), Black, Embedded Audio, Error Detection and Handling (EDH), and Freeze. A sophisticated black detection system is employed to activate the switch in the event signal is lost. It allows the user to select not only the threshold and percentage of non-black pixels, but also the portion of the picture to be considered. The 5420 Logo Inserter module keys a still logo or an animation over program material. Alternately the 5420 can supply separate fill and key to a production switcher. This module can be used in an Avenue 3RU or 1RU frame. Generate logos and animations in your favorite graphics software and then upload them into the 5420’s nonvolatile flash memory. Multiple logos and animations of varying sizes can be stored. Logo position and logo density can be adjusted from the Avenue control system, using an Avenue Touch Screen or Avenue PC, GPIs, serial interface and ethernet are also available for control. Sequences of logos, animations and transitions can be programmed.

The 3RU frame is a full featured chassis that accommodates any ten Avenue modules. Modules plug into a universal motherboard so that rear modules are not needed.
In addition to the ten module slots, there is a dedicated slot for the optional 5030 System Control module. One universal power supply comes with each frame. Redundant supply is optional ( included in this auction) and does not take up a slot in the frame. Touch Screen front door or plain front door are available. Plastic overlays for each module type are provided and slip over the corresponding BNCs on the backplane to identify the input and output designations on each type of module. In addition to the ten audio and video modules, the optional 5030 system control module adds a variety of control capabilities. Please refer to System Control Overview for more information. 5020 Power Supply Each Avenue 3RU frame comes with one 5020 Power Supply module installed. An optional redundant power supply is available if desired to provide backup. Power is provided to all modules in the frame, the front door fan and optional Touch Screen Panel. Frame Specifications The Avenue 3RU (5.25 inches) frame fits in a standard 19 inch rack. Any number of frames may be stacked together in any combination. A fan in the front door of each 3RU frame provides the necessary cooling for the frame. The fan is temperature sensitive and adjusts its speed accordingly. Should the fan fail, a red LED will light on the front panel. If using a remote control option, an alarm can be set to alert the user of fan failure. All critical components such as fuses, filter and fan are made to be accessible from the front of the unit. The 5160 Serial Digital Protection DA module is a fail-safe protection switch for monitoring and switching critical digital paths. When a fault is detected in the Primary input, the switch will activate, causing the Secondary (backup) input to be switched to the module’s distributed outputs. The switch can operate in two modes; automatic or non-resetting. The 5160 monitors the integrity of the Primary serial digital input stream and analyzes the audio and video content. Signal health and fault detection is determined by monitoring any or all of the following parameters: Timing Reference Signal (TRS), Black, Embedded Audio, Error Detection and Handling (EDH), and Freeze. A sophisticated black detection system is employed to activate the switch in the event signal is lost. It allows the user to select not only the threshold and percentage of non-black pixels, but also the portion of the picture to be considered. The 5420 Logo Inserter module keys a still logo or an animation over program material. Alternately the 5420 can supply separate fill and key to a production switcher. This module can be used in an Avenue 3RU or 1RU frame. Generate logos and animations in your favorite graphics software and then upload them into the 5420’s nonvolatile flash memory. Multiple logos and animations of varying sizes can be stored. Logo position and logo density can be adjusted from the Avenue control system, using an Avenue Touch Screen or Avenue PC, GPIs, serial interface and ethernet are also available for control. Sequences of logos, animations and transitions can be programmed.

The 3RU frame is a full featured chassis that accommodates any ten Avenue modules. Modules plug into a universal motherboard so that rear modules are not needed.
In addition to the ten module slots, there is a dedicated slot for the optional 5030 System Control module. One universal power supply comes with each frame. Redundant supply is optional ( included in this auction) and does not take up a slot in the frame. Touch Screen front door or plain front door are available. Plastic overlays for each module type are provided and slip over the corresponding BNCs on the backplane to identify the input and output designations on each type of module. In addition to the ten audio and video modules, the optional 5030 system control module adds a variety of control capabilities. Please refer to System Control Overview for more information. 5020 Power Supply Each Avenue 3RU frame comes with one 5020 Power Supply module installed. An optional redundant power supply is available if desired to provide backup. Power is provided to all modules in the frame, the front door fan and optional Touch Screen Panel. Frame Specifications The Avenue 3RU (5.25 inches) frame fits in a standard 19 inch rack. Any number of frames may be stacked together in any combination. A fan in the front door of each 3RU frame provides the necessary cooling for the frame. The fan is temperature sensitive and adjusts its speed accordingly. Should the fan fail, a red LED will light on the front panel. If using a remote control option, an alarm can be set to alert the user of fan failure. All critical components such as fuses, filter and fan are made to be accessible from the front of the unit. The 5160 Serial Digital Protection DA module is a fail-safe protection switch for monitoring and switching critical digital paths. When a fault is detected in the Primary input, the switch will activate, causing the Secondary (backup) input to be switched to the module’s distributed outputs. The switch can operate in two modes; automatic or non-resetting. The 5160 monitors the integrity of the Primary serial digital input stream and analyzes the audio and video content. Signal health and fault detection is determined by monitoring any or all of the following parameters: Timing Reference Signal (TRS), Black, Embedded Audio, Error Detection and Handling (EDH), and Freeze. A sophisticated black detection system is employed to activate the switch in the event signal is lost. It allows the user to select not only the threshold and percentage of non-black pixels, but also the portion of the picture to be considered. The 5420 Logo Inserter module keys a still logo or an animation over program material. Alternately the 5420 can supply separate fill and key to a production switcher. This module can be used in an Avenue 3RU or 1RU frame. Generate logos and animations in your favorite graphics software and then upload them into the 5420’s nonvolatile flash memory. Multiple logos and animations of varying sizes can be stored. Logo position and logo density can be adjusted from the Avenue control system, using an Avenue Touch Screen or Avenue PC, GPIs, serial interface and ethernet are also available for control. Sequences of logos, animations and transitions can be programmed.

For PDF's and manuals click the following link and download what you need. www.discoveryresources.com/manuals.html Down converts an HD serial digital video signal to an SD component serial digital signal Supports 1080 (1035) i to 485i at 59.94 Hz and 1080i to 576i at 50 Hz conversion Output signal aspect ratio selectable: squeeze, edge crop, semi letter box (13:9, 14:9) and letter box (16:9) Minimum delay/frame delay selectable Remote control from HKDV-503 digital video controller Passes embedded audio Parallel alarm output

The NEO IconLogo can insert up to four (two for HD) independent layers of graphic onto the program feed. Any of the layers (layer one for analog) may be replaced with an external Fill and Key input. A removable compact flash drive provides ample storage for logos, animations and short audio/video clips. Network storage is likewise supported, and provides virtually unlimited logo storage